| ASCII - Command | WMASK | |||
| Syntax Transmit | WMASK [Data] | |||
| Syntax Receive | WMASK <Data> | Available in | ||
| Type | Variable rw | MMI | Yes | |
| ASCII Format | Integer32 | CANBus Object Number | 363E (hex) | |
| DIM | - | PROFIBUS PNU | 1918 (dec) IND = 1 (dec) | |
| Range | -21474836470 ... 21474836470 | DPR | 318 (dec) | |
| Default | 0 | |||
| Opmode | All | Data Type Bus/DPR | Integer32 | |
| Drive State | - | Weighting | ||
| Start Firmware | 1.0 | |||
| Configuration | No | Last Change of this Object | 1.0 | |
| Function Group | drive configuration | EEPROM | No | |
| Short Description | Warning as fault mask | |||
Description
| The WMASK parameter can be used to reconfigure a warning as the fault message F24. The WMASK parameter is a bit-variable, with bit assignments that correspond to the STATCODE * status variable. The bit that is set within the WMAKS variable means that the corresponding warning bit in the STATCODE * variable should generate an F24 fault message, as well as a warning. Unlike warnings, a fault message results in the disabling of the output stage, and the opening of the BTB contact. A reconfiguration of a warning to a fault message can be especially relevant for the following warnings: contouring/following error, threshold detection, hardware limit switch. The value has to be entered in decimal. See also LASTWMASK |