ASCII - Command | O_DEC | |||
Syntax Transmit | O_DEC [Data] | |||
Syntax Receive | O_DEC <Data> | Available in | ||
Type | Variable rw | MMI | Yes | |
ASCII Format | Integer32 | CANBus Object Number | 35BA (hex) | |
DIM | ms, mm/sec ^2 | PROFIBUS PNU | 1786 (dec) IND = 1 (dec) | |
Range | 0 ... 2147483647 | DPR | 186 (dec) | |
Default | 0 | |||
Opmode | All | Data Type Bus/DPR | Integer32 | |
Drive State | - | Weighting | ||
Start Firmware | 1.0 | |||
Configuration | No | Last Change of this Object | 2.6 | |
Function Group | position loop | EEPROM | Yes | |
Short Description | Braking Time 1 for Motion Task 0 |
Description
The command O_DEC can be used to define the deceleration (braking) ramp for motion task 0 (direct motion task). The scaling of the deceleration/braking time depends on the PGEARI, PGEARO and O_C parameters. 1. Bit 12 of the motion task control variable O_C is = 0. The braking time is given in milliseconds for deceleration from target speed O_V down to 0. 2. Bit 12 of the motion task control variable O_C is = 1. The deceleration is given in mm/secē. The resulting run-down time is calculated at the start of the motion task. Note: If the resolution is set to 1 (PGEARI=PGEARO) then internal units (counts) will be used for the speed, position and acceleration. In this case, O_DEC is interpreted as a run-down time in msec. |